Welcome to IronCrossRacing.net product reviews. I will test ATV products and report back to you with a fair and honest judgment of the products I test Good or Bad. To find out more details on how to get your product reviewed, please contact IronCross Racing at sam@ironcrossracing.net

SixsixT Filter Adapter

Well at first glance you can see that the SixsixT Filter Adapter is going to be a much nicer set up than the factory faulty airbox set up. The SixsixT adapter will hold a ProDesign style K&N filter, or the Dual Banshee style K&N filters. I chose the Adapter that was set up to use my Prodesign style K&N Filter. The SixsixT Filter Adapter also has a spot to hold a K&N case breather filter, witch most aftermarket Alum. Airboxes dont. The SixsixT adapter comes with all the hard ware you need to install, and the K&N Case Breather filter. Instalation was a snap. First you need to remove the seat. There is (2) hoses going to the front of the airbox, take a philips head screw driver and loosen them up. On the top sid eof the air box there is (2) 10mm bolts holing it in place. The manual will tell you that you need to remove the rear fenders to get the airbox off, I found that if you pull the front of the box the 2 little plastic line up pins will pop right out of the frame. Then your ready to install your new adapter. It does not come with instructions, but if you were able to get the airbox off you can put the adapter in. It has (2) bolts (2) nuts, and (4) washers that hold it into place where the plastic line up pins go in the frame, (from the factory airbox). Simply put the adapter in place run the bolts up and clamp the filter on. Then your ready to bolt the K&N Case Breather on. The SixsixT airbox elimator works great. It only take about 15 mins to install. Although this set up is not recommended for WET or MUDDY areas, it will work fine for most trails, Dunes, and of course Drag Racing. And at $55 for the SixsixT Airbox Elimanator and K&N case breather Filter you can go wrong.  If you would like to know how to get a hold of this product Please contact us at  sam@ironcrossracing.net